Show Newaddrtrap; Set Newaddrtrap - Enterasys G3G170-24 Cli Reference Manual

show newaddrtrap

Use this command to display the global and port‐specific status of the SNMP new MAC addresses
trap function.
Syntax
show newaddrtrap [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, the status of the new MAC addresses trap function will be displayed
for all ports.
Mode
Switch command, read‐only.
Usage
By default, this function is disabled globally and per port.
Example
This example displays the status for Gigabit Ethernet ports 1 through 5 in slot 1.
G3(ro)->show newaddrtrap ge.1.1-5
New Address Traps Globally disabled
Port
--------- ------------
ge.1.1
ge.1.2
ge.1.3
ge.1.4
ge.1.5

set newaddrtrap

Use this command to enable or disable SNMP trap messaging, globally or on one or more ports,
when new source MAC addresses are detected.
Syntax
set newaddrtrap [port-string] {enable | disable}
Parameters
port‐string
(Optional) Displays the status of the new MAC addresses trap function
on specific ports.
Enable State
disabled
disabled
disabled
disabled
disabled
(Optional) Enable or disable the new MAC addresses trap function on
specific ports.
show newaddrtrap
Enterasys G-Series CLI Reference 5-29