Clear Ip Ospf Process; Show Ip Ospf Virtual Links Output Details - Enterasys G3G170-24 Cli Reference Manual

clear ip ospf process

Example
This example shows how to display OSPF virtual links information:
G3(su)->router#show ip ospf virtual-links
Neighbor ID 155.155.155.155
Transit area 0.0.0.8
Transmit delay is 1 sec State point-to-point
Timer intervals configured:
Adjacency State Full
Table 16‐6 provides an explanation of the command output.
Table 16-6 show ip ospf virtual links Output Details
Output Field
Neighbor ID
Transit area
Transmit delay
State
Timer intervals
configured
Adjacency State
clear ip ospf process
Use this command to reset the OSPF process. This will require adjacencies to be reestablished and
routes to be reconverged.
Syntax
clear ip ospf process process-id
Parameters
process‐id
Defaults
None.
Mode
Privileged EXEC: G3(su)‐>router#
Example
This example shows how to reset OSPF process 1:
G3(su)->router#clear ip ospf process 1
16-30 IPv4 Routing Protocol Configuration
Hello 10, Dead 40, Retransmit 5
What It Displays...
ID of the virtual link neighbor, and the virtual link status, which is up or down.
ID of the transit area through which the virtual link is configured.
Amount of time required to transmit a link state update packet on an interface.
Whether the state of this interface is down or point-to-point.
Timer intervals configured for the virtual link, including Hello, Wait, and Retransmit
intervals.
State of adjacency between this router and the virtual link neighbor of this router.
Specifies the process ID, an internally used identification number for each
instance of the OSPF routing process run on a router. Valid values are 1 to
65535.