neighborid
seconds
Defaults
The default retransmit interval is 5 seconds.
Mode
Router OSPFv3 configuration: G3(su)‐>router(Config‐router)#
Usage
Use the no form of this command to return a configured value to the default value of 5 seconds.
Example
This example sets the retransmit interval to 10 seconds for the specified OSPFv3 virtual interface.
G3(su)->router(Config-router)# area 20 virtual-link 2.2.2.2 retransmit-interval
10
area virtual-link transmit-delay
This command configures the transmit delay for the specified OSPFv3 virtual interface.
Syntax
area areaid virtual-link neighborid transmit-delay seconds
no area areaid virtual-link neighborid transmit-delay
Parameters
areaid
neighborid
seconds
Defaults
The default transmit delay is 1 second.
Mode
Router OSPFv3 configuration: G3(su)‐>router(Config‐router)#
Usage
Use the no form of this command to reset the transmit delay to the default of 1 second.
Specifies the virtual link neighbor by means of its router ID. The router
ID must be entered in 32‐bit dotted‐quad notation.
Specifies the value of the retransmit interval in seconds. The range is
from 1 to 3600 seconds.
Specifies the area ID in IP address format (dotted‐quad) or as a decimal
value.
Specifies the virtual link neighbor by means of its router ID. The router
ID must be entered in 32‐bit dotted‐quad notation.
Specifies the value of the transmit delay in seconds. The range is from 1
to 3600 seconds.
area virtual-link transmit-delay
Enterasys G-Series CLI Reference 19-19