Set Igmpsnooping Interfacemode; Set Igmpsnooping Groupmembershipinterval - Enterasys G3G170-24 Cli Reference Manual

set igmpsnooping interfacemode

Example
This example shows how to enable IGMP on the system:
G3(su)->set igmpsnooping adminmode enable
set igmpsnooping interfacemode
Use this command to enable or disable IGMP on one or all ports.
Syntax
set igmpsnooping interfacemode port-string {enable | disable}
Parameters
port‐string
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
Usage
In order for IGMP snooping to be enabled on one or all ports, it must be globally enabled on the
device using the set igmpsnooping adminmode command as described in "set igmpsnooping
adminmode" on page 10‐3, and then enabled on a port(s) using this command.
Example
This example shows how to enable IGMP on port
G3(su)->set igmpsnooping interfacemode ge.1.10 enable

set igmpsnooping groupmembershipinterval

Use this command to configure the IGMP group membership interval time for the system.
Syntax
set igmpsnooping groupmembershipinterval time
Parameters
time
10-4 IGMP Configuration
Specifies one or more ports on which to enable or disable IGMP.
Enables or disables IGMP.
Specifies the IGMP group membership interval. Valid values are 2 ‐ 3600
seconds.
This value works together with the set igmpsnooping maxresponsetime
command to remove ports from an IGMP group and must be greater than
the max response time value.
ge .1.10: