Defaults
None.
Mode
Switch command, read‐write.
Example
This example enables transmitting LLDP traps on ports
G3(rw)->set lldp port trap enable ge.1.1-6
set lldp port med-trap
Use this command to enable or disable sending an LLDP‐MED notification when a change in the
topology has been sensed on the port (that is, a remote endpoint device has been attached or
removed from the port).
Syntax
set lldp port med-trap {enable | disable} port-string
Parameters
enable
disable
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example enables transmitting LLDP‐MED traps on ports
G3(rw)->set lldp port med-trap enable ge.1.1-6
set lldp port location-info
Use this command to configure LLDP‐MED location information on a port or range of ports.
Currently, only Emergency Call Services (ECS) Emergency Location Identification Number
(ELIN) is supported.
Syntax
set lldp port location-info elin elin-string port-string
Enables transmitting LLDP‐MED traps on the specified ports.
Disables transmitting LLDP‐MED traps on the specified ports.
Specifies the port or range of ports to be affected.
ge
.1.1 through
ge
.1.6.
ge
.1.1 through
ge
.1.6.
Enterasys G-Series CLI Reference 3-25
set lldp port med-trap