Show Radius; Set Radius; Show Radius Output Details - Enterasys G3G170-24 Cli Reference Manual

show radius

show radius
Use this command to display the current RADIUS client/server configuration.
Syntax
show radius [status | retries | timeout | server [index | all]]
Parameters
status
retries
timeout
server
index | all
Defaults
If no parameters are specified, all RADIUS configuration information will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display RADIUS configuration information:
G3(rw)->show radius
RADIUS status:
RADIUS retries:
RADIUS timeout:
RADIUS Server
--------------
10
Table 20‐1 provides an explanation of the command output.
Table 20-1 show radius Output Details
Output Field
RADIUS status
RADIUS retries
RADIUS timeout
RADIUS Server
20-4 Security Configuration
(Optional) Displays the RADIUS server's enable status.
(Optional) Displays the number of retry attempts before the RADIUS server
times out.
(Optional) Displays the maximum amount of time (in seconds) to establish
contact with the RADIUS server before retry attempts begin.
(Optional) Displays RADIUS server configuration information.
For use with the server parameter to show server configuration for all
servers or a specific RADIUS server as defined by an index.
Enabled
3
20 seconds
IP Address Auth-Port
---------- ---------
172.16.20.10
What It Displays...
Whether RADIUS is enabled or disabled.
Number of retry attempts before the RADIUS server times out. The default value of 3
can be reset using the set radius command as described in
page 20-5.
Maximum amount of time (in seconds) to establish contact with the RADIUS server
before retry attempts begin. The default value of 20 can be reset using the set
radius command as described in
RADIUS server's index number, IP address, and UDP authentication port.
Realm-Type
-----------------
1812 management-access
"set radius" on page 20-5.
"set radius" on