Show Ipv6 Ospf Area - Enterasys G3G170-24 Cli Reference Manual

Table 19-1 show ipv6 ospf Output Details
Output Field
New LSAs Originated
LSAs Received
External LSDB Limit
Default Metric
Maximum Paths
Default Route Advertise
Always
Metric
Metric Type

show ipv6 ospf area

This command displays information about the specified OSPFv3 area.
Syntax
show ipv6 ospf area areaid
Parameters
areaid
Defaults
None.
Mode
Router privileged execution: G3(su)‐>router#
Example
This example shows how to display OSPFv3 information for area 20.
G3(su)->router>show ipv6 ospf area 20
AreaID
External Routing
Spf Runs
Area Border Router Count
Area LSA Count
Area LSA Checksum
Stub Mode
Table 19‐2
Specifies the area ID in IP address format (dotted‐quad) or as a decimal
value.
provides an explanation of the command output.
What It Displays...
The number of new link-state advertisements that have been
originated.
The number of link-state advertisements received determined to
be new instantiations.
The maximum number of non-default AS-external-LSAs entries
that can be stored in the link-state database.
Default value for redistributed routes.
The maximum number of paths that OSPF can report for a given
destination.
Whether the default routes received from other source protocols
are advertised or not.
Whether default routes are always advertised.
The metric for the advertised default routes. If the metric is not
configured, this field is blank.
Whether the routes are External Type 1 or External Type 2.
0.0.0.20
Import NSSAs
7
0
5
188094
Disable
show ipv6 ospf area
Enterasys G-Series CLI Reference 19-29