Ip Address; Show Ip Interface Output Details - Enterasys G3G170-24 Cli Reference Manual

G-series
Hide thumbs Also See for G3G170-24:
Table of Contents

Advertisement

Table 15-1 show ip interface Output Details
Output Field
Vlan N
Primary IP Address
Frame Type
MAC-Address
Incoming Access
List
Outgoing Access
List
MTU
ARP Timeout
Direct Broadcast
Proxy Arp

ip address

Use this command to set, remove, or disable a primary or secondary IP address for an interface. 
The no form of this command removes the specified IP address and disables the interface for IP 
processing.
Syntax
ip address ip-address ip-mask [secondary]
no ip address ip-address ip-mask
Parameters
ip‐address
ip‐mask
secondary
Defaults
If secondary is not specified, the configured address will be the primary address for the interface.
Mode
Router interface configuration: G3(su)‐>router(Config‐if(Vlan 1))# 
Usage
Each G‐Series system supports up to 24 routing interfaces, with up to 8 secondary addresses 
allowed for each primary IP address. 
What It Displays...
Whether the interface is administratively and operationally up or down.
Inteface's primary IP address and mask. Set using the ip address command as
described in
"ip
address" on page 15-5.
Encapsulation type used by this interface. Set using the arp command as described
in "arp" on page 15-12.
MAC address mapped to this interface.
Whether or not an access control list (ACL) has been configured for ingress on this
interface using the commands described in
page 20-70.
Not supported.
Interface's Maximum Transmission Unit size.
Duration for entries to stay in the ARP table before expiring. Set using the arp
timeout command as described in
Whether or not IP directed broadcast is enabled. Set using the ip directed-broadcast
command described in
"ip
Whether or not proxy ARP is enabled or disabled for this interface. Set using the ip
proxy arp command as described in
Specifies the IP address of the interface to be added or removed. 
Specifies the mask for the associated IP subnet.
(Optional) Specifies that the configured IP address is a secondary address. 
"Configuring Access
"arp
timeout" on page 15-14.
directed-broadcast" on page 15-15.
"ip
proxy-arp" on page 15-13.
Enterasys G-Series CLI Reference 15-5
ip address
Lists" on

Advertisement

Table of Contents
loading

Table of Contents