Example
This example shows how to enable RIP:
G3(su)->router#configure
G3(su)->router(Config)#router rip
G3(su)->router(Config-router)#
ip rip enable
Use this command to enable RIP on an interface. The no form of this command disables RIP on an
interface: By default, RIP is disabled on all interfaces.
Syntax
ip rip enable
no ip rip enable
Parameters
None.
Defaults
None.
Mode
Interface configuration: G3
Example
This example shows how to enable RIP on the VLAN 1 interface:
G3(su)->router(Config)#interface vlan 1
G3(su)->router(Config-if(Vlan 1))#ip rip enable
distance
Use this command to configure the administrative distance for RIP routes. The no form of this
command resets RIP administrative distance to the default value of 120.
Syntax
distance weight
no distance [weight]
Parameters
weight
Defaults
None.
Mode
Router configuration: G3(su)‐>router(Config‐router)#
(su)‐>router(Config‐if(Vlan 1))#
Specifies an administrative distance for RIP routes. Valid values are 1 ‐ 255.
ip rip enable
Enterasys G-Series CLI Reference 16-3