Show Multiauth Session-Timeout - Enterasys G3G170-24 Cli Reference Manual

Parameters
dot1x
mac
pwa
Defaults
If no authentication method is specified, the idle timeout value is reset to its default value of 0 for
all authentication methods.
Mode
Switch mode, read‐write.
Example
This example resets the idle timeout value for all authentication methods to 0 seconds.
G3(su)->clear multiauth idle-timeout

show multiauth session-timeout

Use this command to display the session timeout value, in seconds, for all authentication methods.
Syntax
show multiauth session-timeout
Parameters
None.
Defaults
None.
Mode
Switch mode, read‐only.
Example
This example displays the session timeout values for all authentication methods.
G3(su)->show multiauth session-timeout
Authentication type
------------------- -------------
dot1x
pwa
mac
(Optional) Specifies the IEEE 802.1X port‐based network access control
authentication method for which to reset the timeout value to its
default.
(Optional) Specifies the Enterasys MAC authentication method for
which to reset the timeout value to its default.
(Optional) Specifies the Enterasys Port Web Authentication method for
which to reset the timeout value to its default.
Timeout (sec)
0
0
0
show multiauth session-timeout
Enterasys G-Series CLI Reference 20-39