Enterasys G3G170-24 Cli Reference Manual page 38

Factory Default Settings
Table 1-1 Default Settings for Basic Switch and Router Operation (Continued)
Feature
Rate limiting
SNMP
SNTP
Spanning Tree
Spanning Tree edge port
administrative status
Spanning Tree edge port
delay
Spanning Tree forward
delay
Spanning Tree hello
interval
Spanning Tree ID (SID)
Spanning Tree maximum
aging time
Spanning Tree port priority
Spanning Tree priority
Spanning Tree topology
change trap suppression
Spanning Tree version
SSH
System baud rate
System contact
System location
System name
Terminal
Timeout
User names
VLAN dynamic egress
VLAN ID
Host VLAN
Router Mode Defaults
Access groups (IP security) None configured.
Access lists (IP security)
Area authentication
(OSPF)
Area default cost (OSPF)
1-4 Introduction
Default Setting
Disabled (globally and on all ports).
Enabled.
Disabled.
Globally enabled and enabled on all ports.
Edge port administrative status begins with the value set to false initially after
the device is powered up. If a Spanning Tree BDPU is not received on the
port within a few seconds, the status setting changes to true.
Enabled.
Set to 15 seconds.
Set to 2 seconds.
Set to 0.
Set to 20 seconds.
All ports with bridge priority are set to 128 (medium priority).
Bridge priority is set to 32768.
Enabled.
Set to mstp (Multiple Spanning Tree Protocol).
Disabled.
Set to 9600 baud.
Set to empty string.
Set to empty string.
Set to empty string.
CLI display set to 80 columns and 24 rows.
Set to 5 minutes.
Login accounts set to ro for Read-Only access; rw for Read-Write access;
and admin for Super User access.
Disabled on all VLANs.
All ports use a VLAN identifier of 1.
Default host VLAN is 1.
None configured.
Disabled.
Set to 1.