Ipv6 Mtu - Enterasys G3G170-24 Cli Reference Manual

Mode
Router interface configuration: G3(su)‐>router(Config‐if(Vlan 1))#
Usage
When this command is executed, an IPv6 link‐local unicast address is configured on the interface
and IPv6 processing is enabled. You do not need to use this command if you configured an IPv6
global address on an interface with the ipv6 address command.
The no ipv6 enable command disables IPv6 routing on an interface that has been enabled with the
ipv6 enable command, but it does not disable IPv6 processing on an interface that is configured
with an explicit IPv6 address.
Example
This example enables IPv6 processing on VLAN 7. Note that a link‐local address has been
automatically configured.
G3(su)->router(Config-if(Vlan 7))# ipv6 enable
G3(su)->router>show ipv6 interface vlan 7
Vlan 7 Administrative Mode
Vlan 7 IPv6 Routing Operational Mode
IPv6 is
IPv6 Prefix is
Routing Mode
Interface Maximum Transmit Unit
Router Duplicate Address Detection Transmits
Router Advertisement NS Interval
Router Lifetime Interval
Router Advertisement Reachable Time
Router Advertisement Interval
Router Advertisement Managed Config Flag
Router Advertisement Other Config Flag
Router Advertisement Suppress Flag

ipv6 mtu

This command configures the maximum transmission unit (MTU) size of IPv6 packets that can be
sent on an interface.
Syntax
ipv6 mtu bytes
no ipv6 mtu
Parameters
bytes
Defaults
1480 bytes
Mode
Router interface configuration: G3(su)‐>router(Config‐if(Vlan 1))#
Specifies the MTU value in bytes. The value can range from 1280 to 1500
bytes. The MTU cannot be larger than the value supported by the
underlying interface.
Enabled
Enabled
Enabled
FE80::211:88FF:FE55:4A7F/128
Enabled
1500
1
0
1800
0
600
Disabled
Disabled
Disabled
Enterasys G-Series CLI Reference 18-11
ipv6 mtu