Show Ipv6 Route Preferences; Show Ipv6 Route Output Details - Enterasys G3G170-24 Cli Reference Manual

show ipv6 route preferences

Example
This example displays all active IPv6 routes.
G3(su)->router>show ipv6 route
IPv6 Routing Table - 5 entries
Codes: C - connected, S - static
S ::/0 [1/0]
C 3FFE:501:FFFF:100::/64 [0/0]
C 3FFE:501:FFFF:101::/64 [0/0]
C 3FFE:501:FFFF:108::/64 [0/0]
S 3FFE:501:FFFF:109::/64 [1/0]
Table 18‐2 provides an explanation of the command output.
Table 18-2 show ipv6 route Output Details
Output Field
Codes:
Codes column
IPv6 prefix/prefix-length
[ Preference / Metric ]
Tag
via Next-hop
Interface
show ipv6 route preferences
This command shows the preference value associated with the type of route.
Syntax
show ipv6 route preference
Parameters
None.
18-24 IPv6 Configuration
O - OSPF Intra, OI - OSPF Inter, OE1 - OSPF Ext 1, OE2 - OSPF Ext 2
ON1 - OSPF NSSA Ext Type 1, ON2 - OSPF NSSA Ext Type 2
via FE80::2D0:B7FF:FE2C:7694,
via ::, Vlan 6
via ::, Vlan 7
via ::, Vlan 6
via 3FFE:501:FFFF:100:200:FF:FE00:A1A1,
via FE80::200:FF:FE00:A1A1,
Vlan 6
Vlan 6
Vlan 6
What It Displays...
Key for the routing protocol codes that might appear in the Codes
column of the routing table output.
The code for the routing protocol that created this routing entry.
The IPv6 prefix and prefix length of the destination IPv6 network
corresponding to this route.
The administrative distance (preference) and cost (metric)
associated with this route.
The decimal value of the tag associated with a redistributed route,
if it is not 0.
The outgoing router IPv6 address to use when forwarding traffic to
the next router, if any, in the path toward the destination.
The outgoing router interface to use when forwarding traffic to the
next destination.