area nssa translator-stab-intv
area nssa translator-stab-intv
This command configures the translator stability interval of the NSSA.
Syntax
area areaid translator-stab-intv interval
no area areaid translator-stab-intv
Parameters
areaid
interval
Defaults
The default interval is 40 seconds.
Mode
Router OSPFv3 configuration: G3
Usage
The stability interval is the period of time that an elected translator continues to perform its duties
after it determines that its translator status has been deposed by another router.
Example
This example sets the translator stability interval to 60 seconds for NSSA 20.
G3(su)->router(Config-router)# area 20 nssa translator-stab-intv 60
area range
This command creates an address range for the specified NSSA.
Syntax
area areaid range ipv6-prefix/prefix-length {summarylink | nssaexternallink}
[advertise | not-advertise]
no area areaid range ipv6-prefix/prefix-length
Parameters
areaid
ipv6‐prefix/prefix‐length Specifies IPv6 prefix and the length of the IPv6 prefix for the address
summarylink
19-14 OSPFv3 Configuration
Specifies the area ID in IP address format (dotted‐quad) or as a decimal
value.
Specifies the stability interval in seconds. The value of interval can range
from 0 to 3600 seconds.
(su)->router(Config-router)#
Specifies the area ID in IP address format (dotted‐quad) or as a decimal
value.
range. The prefix must be specified in hexadecimal using 16‐bit values
between colons.
The value of prefix‐length is a decimal number indicating the number of
high‐order contiguous bits that comprise the prefix.
Specifies that route summarization should be based on summary LSAs.