Enterasys G3G170-24 Cli Reference Manual page 279

For information about...
show port ingress filter
set port ingress filter
show port discard
set port discard
show port vlan
Use this command to display port VLAN identifier (PVID) information. PVID determines the
VLAN to which all untagged frames received on one or more ports will be classified.
Syntax
show port vlan [port-string]
Parameters
port‐string
Defaults
If port ‐string is not specified, port VLAN information for all ports will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display PVIDs assigned to ge.2.1 through 6. In this case, untagged
frames received on these ports will be classified to VLAN 1:
G3(su)->show port vlan ge.2.1-6
ge.2.1 is set to 1
ge.2.2 is set to 1
ge.2.3 is set to 1
ge.2.4 is set to 1
ge.2.5 is set to 1
ge.2.6 is set to 1
set port vlan
Use this command to configure the PVID (port VLAN identifier) for one or more ports.
Syntax
set port vlan port-string pvid [modify-egress | no-modify-egress]
(Optional) Displays PVID information for specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 4‐1.
show port vlan
Refer to page...
7-9
7-9
7-10
7-11
Enterasys G-Series CLI Reference 7-7