Clear Dhcp Pool Netbios-Name-Server; Set Dhcp Pool Netbios-Node-Type - Enterasys G3G170-24 Cli Reference Manual

Parameters
poolname
address
address2 ... address8
Defaults
None.
Mode
Switch command, read‐write.
Example
This example assigns a NetBIOS name server at 10.15.10.1 to the address pool being configured.
G3(rw)->set dhcp pool auto1 netbios-name-server 10.15.10.1

clear dhcp pool netbios-name-server

Use this command to remove the NetBIOS namer server list from the address pool being
configured.
clear dhcp pool poolname netbios-name-server
Parameters
poolname
Defaults
None.
Mode
Switch command, read‐write.
Example
This example removes the NetBIOS name server list from the address pool auto1.
G3(rw)->clear dhcp pool auto1 netbios-name-server

set dhcp pool netbios-node-type

Use this command to specify a NetBIOS node (server) type for the DHCP clients served by the
address pool being configured.
Syntax
set dhcp pool poolname netbios-node-type {b-node | h-node | p-node | m-node}
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the IP address of a NetBIOS name server.
(Optional) Specifies, in order of preference, up to 7 additional NetBIOS
name server addresses.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
clear dhcp pool netbios-name-server
Enterasys G-Series CLI Reference 13-25