Configuring General DHCP Server Parameters
Purpose
To configure DHCP server parameters, and to display and clear address binding information,
server statistics, and conflict information.
Commands
For information about...
set dhcp
set dhcp bootp
set dhcp conflict logging
show dhcp conflict
clear dhcp conflict
set dhcp exclude
clear dhcp exclude
set dhcp ping
clear dhcp ping
show dhcp binding
clear dhcp binding
show dhcp server statistics
clear dhcp server statistics
set dhcp
Use this command to enable or disable the DHCP server functionality on the G‐Series.
Syntax
set dhcp {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
Enables or disables DHCP server functionality. By default, DHCP server
is disabled.
Configuring General DHCP Server Parameters
Refer to page...
13-3
13-4
13-4
13-5
13-5
13-6
13-6
13-7
13-7
13-8
13-8
13-9
13-10
Enterasys G-Series CLI Reference 13-3