Ip Vrrp Authentication-Key - Enterasys G3G170-24 Cli Reference Manual

ip vrrp authentication-key

no enable vlan vlan-id vrid
Parameters
vlan vlan‐id
vrid
Defaults
None.
Mode
Router configuration: G3(su)‐>router(Config‐router)#
Example
This example shows how to enable VRRP on the VLAN 1 interface, VRID 1:
G3(su)->router(Config)#router vrrp
G3(su)->router(Config-router)#enable vlan 1 1
ip vrrp authentication-key
Use this command to enable or disable a VRRP authentication key (password) for use on an
interface. The no form of this command prevents VRRP from using authentication.
Syntax
ip vrrp authentication-key name
no ip vrrp authentication-key
Parameters
name
Defaults
None.
Mode
Interface configuration: G3(su)‐>router(Config‐if(Vlan 1))#
Example
This example shows how to set the VRRP authentication key chain to "password" on the VLAN 1
interface:
G3(su)->router(Config)#interface vlan 1
G3(su)->router(Config-if(Vlan 1))#ip vrrp authentication-key password
16-44 IPv4 Routing Protocol Configuration
Specifies the number of the VLAN on which to enable VRRP. This VLAN
must be configured for IP routing as described in "Pre‐Routing
Configuration Tasks" on page 14‐1.
Specifies the Virtual Router ID (VRID) associated with the vlan‐id. Valid
values are from 1 to 255.
Specifies the password to enable or disable for VRRP authentication.