Traceroute - Enterasys G3G170-24 Cli Reference Manual

traceroute

Examples
This example shows output from a successful ping to IP address 182.127.63.23:
G3(su)->router#ping 182.127.63.23
182.127.63.23 is alive
This example shows output from an unsuccessful ping to IP address 182.127.63.24:
G3(su)->router#ping 182.127.63.24
no answer from 182.127.63.24
traceroute
Use this command to display a hop‐by‐hop path through an IP network from the device to a
specific destination host. Three ICMP probes will be transmitted for each hop between the source
and the traceroute destination.
Syntax
traceroute host
Parameters
host
Defaults
None.
Mode
Privileged EXEC: G3(su)‐>router#
Usage
There is also a traceroute command available in switch mode.
Example
This example shows how to use traceroute to display a round trip path to host 192.141.90.183.
G3(su)->router#traceroute 192.141.90.183
Traceroute to 192.141.90.183, 30 hops max, 40 byte packets
1 10.1.56.1
2 10.1.48.254
3 10.1.0.2
4 192.141.89.17
5 192.141.100.13
6 192.141.100.6
7 192.141.90.183
15-20 IP Configuration
Specifies a host to which the route of an IP packet will be traced.
0.000 ms
10.000 ms
0.000 ms
0.000 ms
0.000 ms
0.000 ms
0.000 ms
0.000 ms
0.000 ms
0.000 ms
0.000 ms
10.000 ms
0.000 ms
0.000 ms
0.000 ms
0.000 ms
0.000 ms
10.000 ms
0.000 ms
10.000 ms
0.000 ms