Configuring Policy Class Of Service (Cos); About Policy-Based Cos Configurations - Enterasys G3G170-24 Cli Reference Manual

Configuring Policy Class of Service (CoS)

The G‐Series supports Class of Service (CoS), which allows you to assign mission‐critical data to a
higher priority through the device by delaying less critical traffic during periods of congestion.
The higher priority traffic going through the device is serviced first (before lower priority traffic).
The Class of Service capability of the device is implemented by a priority queueing mechanism.
Class of Service is based on the IEEE 802.1D (802.1p) standard specification, and allows you to
define eight priorities (0‐7, with 7 granted highest priority) and up to 8 transmit queues (0‐7) for
each port.
By default, policy‐based CoS is disabled on the device, and default or user‐assigned port‐based
802.1D (802.1p) settings are used to determine traffic rate limiting. When policy‐based CoS is
enabled, the default and user‐assigned policy‐based settings will override port‐based settings
described in Chapter

About Policy-Based CoS Configurations

Once enabled using the set cos state command as described in "set cos state" on page 8‐17, you
can add to the policy‐based CoS function by defining new port groupings, and assigning inbound
rate limiters. The process for user‐defined CoS configuration involves the following steps and
associated commands listed in Procedure
Procedure 8-1 User-Defined CoS Configuration
Step
1.
2.
3.
4.
5.
Example
This example creates different inbound rate limiters for two port groups and then assigns them to
traffic with a CoS setting of 0.
1. Configure two port groups, one for user ports and one for uplink ports and assign ports to the
groups. Port group 1.0 will represent user ports, group 2.0 will represent uplink ports.
G3(su)->set cos port-config irl 1.0 name Users ports ge.1.1-46
G3(su)->set cos port-config irl 2.0 name Uplink ports ge.1.47-48
G3(su)->show cos port-config
Inbound Rate Limiting Port Configuration Entries
----------------------------------------------------------------------
Port Group Name
Port Group
Port Type
Assigned Ports
Note: It is recommended that you use Enterasys Networks NetSight Policy Manager as an
alternative to CLI for configuring policy-based CoS on the switches.
9.
Task
Enable CoS
Create CoS port groups
Define physical rate limiters for groups
Create virtual reference for the IRL resource
(physical reference) for each port group
Add IRL reference to CoS settings table
:Default
:0
:0
:none
Configuring Policy Class of Service (CoS)
8‐1. An example follows the procedure.
Command(s)
set cos state
set cos port-config
set cos port-resource
set cos reference
set cos settings
Enterasys G-Series CLI Reference 8-15