Show Ipv6 Route Preferences Output Details - Enterasys G3G170-24 Cli Reference Manual

Defaults
None.
Mode
Router privileged execution: G3(su)‐>router#
Router user execution: G3(su)‐>router>
Usage
Lower numbers have a greater preference. A route with a preference of 255 cannot be used to
forward traffic.
The default preference value for static routes can be set with the ipv6 route distance command.
The distance for a specific static route can be set with the ipv6 route command.
Note: The configuration of NSSA preferences is not supported in this release.
Example
The following example shows the output of this command.
G3(su)->router#show ipv6 route preferences
Local
Static
OSPF Intra
OSPF Inter
OSPF Ext T1
OSPF Ext T2
OSPF NSSA T1
OSPF NSSA T2
Table 18‐3 provides an explanation of the command output.
Table 18-3 show ipv6 route preferences Output Details
Output Field
Local
Static
OSPF Intra
OSPF Inter
OSPF Ext T1
OSPF Est T2
OSPF NSSA T1
OSPF NSS! T2
0
1
8
10
13
150
14
151
What It Displays...
Preference of directly-connected routes.
Preference of static routes.
Preference of routes within the OSPF area.
Preference of routes to other OSPF routes that are outside of the
area.
Preference of OSPF Type-1 external routes.
Preference of OSPF Type-2 external routes.
Preference of OSPF NSSA Type 1 routes.
Preference of OSPF NSSA Type 2 routes.
show ipv6 route preferences
Enterasys G-Series CLI Reference 18-25