Configuring Access Lists; Purpose; Show Access-Lists - Enterasys G3G170-24 Cli Reference Manual

Configuring Access Lists

Defaults
If reinitialize is not specified, the user must supply SSH authentication key values.
Mode
Switch command, read‐write.
Example
This example shows how to regenerate SSH keys:
G3(su)->set ssh hostkey reinitialize
Configuring Access Lists

Purpose

To review and configure security access control lists (ACLs), which permit or deny access to
routing interfaces based on protocol and IP address restrictions.
Commands
For information about...

show access-lists

access-list (standard)
access-list (extended)
ip access-group
show access-lists
Use this command to display configured IP access lists when operating in router mode.
Syntax
show access‐lists [number]
Parameters
access‐list‐
number
Defaults
If number is not specified, the entire table of access lists will be displayed.
20-70 Security Configuration
Router: These commands can be executed when the device is in router mode only. For details
on how to enable router configuration modes, refer to
page 14-2.
(Optional) Displays access list information for a specific access list number.
Valid values are between 1 and 199.
"Enabling Router Configuration
Refer to page...
20-70
20-74
20-72
20-74
Modes" on