Show Ipv6 Ospf Database - Enterasys G3G170-24 Cli Reference Manual

show ipv6 ospf database

Table 19-4 show ipv6 ospf asbr Output Details (Continued)
Output Field
Router ID
Cost
Area ID
Next Hop
Next Hop Intf
show ipv6 ospf database
This command displays information about the link state database when OSPFv3 is enabled.
Syntax
show ipv6 ospf [areaid] database [{external | inter-area {prefix | router} | link |
network | nssa-external | prefix | router | unknown {area | as | link}}]
[lsid] [{adv-router [rtrid] | self-originate | database-summary}]
Parameters
areaid
external
inter‐area
prefix
router
link
network
nssa‐external
unknown
{area | as | link}
lsid
adv‐router [rtrid]
self‐originate
database‐summary
Defaults
If no parameters are entered, LSA headers for all areas are displayed.
Mode
Router privileged execution: G3(su)‐>router#
19-32 OSPFv3 Configuration
What It Displays...
Router ID of the destination.
Cost of using this route.
The area ID of the area from which this route is learned.
Address of the next hop toward the destination.
The outgoing router interface to use when forwarding traffic to the
next hop.
(Optional) Display database information about a specific area. Enter the
area ID in IP address format (dotted‐quad) or as a decimal value.
(Optional) Display external LSAs.
(Optional) Display inter‐area LSAs.
(Optional) Display intra‐area Prefix LSAs.
(Optional) Display router LSAs.
(Optional) Display link LSAs.
(Optional) Display network LSAs.
(Optional) Display NSSA external LSAs.
(Optional) Display unknown area, unknown AS, or unknown link
LSAs.
(Optional) Specifies the link state ID.
(Optional) Display the LSAs that are restricted by the advertising
router. Optionally, specify the router by its router ID (rtrid), entered as a
32‐bit dotted‐quad value.
(Optional) Display LSAs that are self‐originated.
(Optional) Displays the number of each type of LSA in the database and
the total number of LSAs in the database.