Set Vlanauthorization - Enterasys G3G170-24 Cli Reference Manual

Parameters
policy
tunnel
Defaults
Set to policy.
Mode
Switch command, read‐write.
Examples
This example shows how to set the policy maptable response to tunnel:
G3(rw)-> set policy maptable response tunnel

set vlanauthorization

Enable or disable the use of the RADIUS VLAN tunnel attribute to put a port into a particular
VLAN based on the result of authentication.
Syntax
set vlanauthorization {enable | disable} [port-string]
Parameters
enable | disable
port‐string
Defaults
VLAN authentication is disabled by default.
Mode
Switch command, read‐write.
Examples
This example shows how to enable VLAN authentication for all Gigabit Ethernet ports:
G3(rw)-> set vlanauthorization enable ge.*.*
This example shows how to disable VLAN authentication for all Gigabit Ethernet ports on switch
unit/module 3:
G3(rw)-> set vlanauthorization disable ge.3.*
Sets the maptable response to policy. This is the default setting, which
allows authentication of up to 8 multiauth users per port.
Sets the maptable response to tunnel, which allows authentication of up
to 8 multiauth users per port. This setting is required to configure VLAN
authorization for multiple users per Gigabit port.
Enables or disables vlan authorization/tunnel attributes.
(Optional) Specifies which ports to enable or disable the use of VLAN
tunnel attributes/authorization. For a detailed description of possible port‐
string values, refer to "Port String Syntax Used in the CLI" on page 4‐1.
set vlanauthorization
Enterasys G-Series CLI Reference 20-43