Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the method used to acquire a network IP address:
G3(su)->show ip protocol
System IP address acquisition method: dhcp
set ip protocol
Use this command to specify the protocol used to acquire a network IP address for switch
management.
Syntax
set ip protocol {bootp | dhcp | none}
Parameters
bootp
dhcp
none
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the method used to acquire a network IP address to DHCP.
G3(su)->set ip protocol dhcp
show system
Use this command to display system information, including contact information, power and fan
tray status and uptime.
Syntax
show system
Selects BOOTP as the protocol to use to acquire the system IP address.
Selects DHCP as the protocol to use to acquire the system IP address.
No protocol will be used to acquire the system IP address.
set ip protocol
Enterasys G-Series CLI Reference 2-11