Set Lacp Static - Enterasys G3G170-24 Cli Reference Manual

set lacp static

aadminkey port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear the actor admin key for LAG port 6:
G3(su)->clear lacp aadminkey lag.0.6
set lacp static
Use this command to disable or enable static link aggregation, or to assign one or more underlying
physical ports to a Link Aggregation Group (LAG).
Syntax
set lacp static {disable | enable} | lagportstring [key] port-string
Parameters
disable | enable
lagportstring
key
port‐string
Defaults
If not specified, a key will be assigned according to the specified aggregator. For example a key of 4
would be assigned to lag.0.4.
Mode
Switch command, read‐write.
Example
This example shows how to add port
G3(su)->set lacp static lag.0.6 ge.1.6
4-40 Port Configuration
Resets admin keys for one or more ports to the default value of 32768.
Disables or enables static link aggregation.
Specifies the LAG aggregator port to which new ports will be assigned.
(Optional) Specifies the new member port and LAG port aggregator
admin key value. Only ports with matching keys are allowed to
aggregate. Valid values are 0 ‐ 65535.
Note: This key value must be unique. If ports other than the desired
underlying physical ports share the same admin key value, aggregation
will fail or undesired aggregations will form.
Specifies the member port(s) to add to the LAG. For a detailed description
of possible port‐string values, refer to "Port String Syntax Used in the CLI"
on page 4‐1.
ge .1.6 to the LAG of aggregator port 6: