Table of Contents
Advertisement
IP Clear and Show Commands
Sample Output
The following is sample output from the command:
XSR>show ip proxy-dns cache
Name
www.enterasys.com
www.test.com
Parameter Description
Name
Age
show ip route
This command displays information about the Routing Table including route types, IP addresses,
and costs. Administrative distances are referenced in each Routing Table entry within the brackets
as follows: [distance/metric]. The command also displays all alternative routes where more than
one route exists to a destination.
Syntax
show ip route [connected | address [mask [longer-prefixes]]| bgp | ospf | rip |
static]
connected
address
mask
longer-prefixes
bgp
ospf
rip
static
Mode
EXEC or Global configuration:
Defaults
•
LAN (FastEthernet 1, 2) interface cost: 10
•
Serial interface cost: 64
5-174 Configuring the Internet Protocol
Designation of the DNS query.
Seconds remaining for the lifetime of the cache.
Shows only connected routes.
Address about which routing data will be shown.
Argument for a subnet mask.
The address and mask pair becomes a prefix and any routes that match
the prefix are displayed.
Shows BGP routes.
Shows OSPF routes.
Shows RIP routes.
Shows static routes.
Note: Bracketed values indicate route distance and cost, where the first value is distance and the
second is cost. For example, [120/0003] indicates a distance of 120 (the default distance for RIP)
and a cost of 3.
Age(sec)
100
10
XSR>
or
XSR(config)#
Advertisement
Table of Contents
