Assigning A Trunk Port To A Vlan - 3Com S7906E Configuration Manual

Before assigning an access port to a VLAN, create the VLAN first.
After you configure a command on a Layer 2 aggregate interface, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do
that on the aggregate interface, it stops applying the configuration to the aggregation member ports.
If it fails to do that on an aggregation member port, it simply skips the port and moves to the next
port.

Assigning a Trunk Port to a VLAN

A trunk port can carry multiple VLANs. You can assign it to a VLAN in interface view (including Ethernet
interface view, Layer 2 aggregate interface view) or port group view.
Follow these steps to assign a trunk port to one or multiple VLANs:
To do...
Enter system view
Enter
interface view
(including
Ethernet
interface
view, Layer 2
aggregate
interface
view) or port
group view
Configure the link type of the
port or ports as trunk
Assign the trunk port(s) to the
specified VLAN(s)
Configure the default VLAN of
the trunk port(s)
Use the command...
system-view
Enter
interface interface-type
Ethernet
interface-number
interface view
Enter Layer 2
interface bridge-aggregation
aggregate
interface-number
interface view
Enter port port-group manual
group view port-group-name
port link-type trunk
port trunk permit vlan
{ vlan-id-list | all }
port trunk pvid vlan vlan-id
—
Required
Use either command.
Required
Required
By default, a trunk port carries
only VLAN 1.
Optional
VLAN 1 is the default VLAN by
default.
1-8
Remarks
In Ethernet interface view, the
subsequent configurations
apply to the current port.
In port group view,
subsequent configurations
apply to all ports in the port
group.
In Layer 2 aggregate interface
view, the subsequent
configurations apply to the
Layer 2 aggregate interface
and all its member ports.
the