Assigning An Ethernet Port To A Vlan - 3Com 4200G 12-Port Configuration Manual

To do...
Enter system view
Enter Ethernet port view
Configure the port link type
To change the link type of a port from trunk to hybrid or vice versa, you need to set the link type to
access first.

Assigning an Ethernet Port to a VLAN

You can assign an Ethernet port to a VLAN in Ethernet port view or VLAN view.
1) In Ethernet port view
Follow these steps to assign an Ethernet port to one or multiple VLANs:
To do...
Enter system view
Enter Ethernet port view
Access port
Assign the
port to one Trunk port
or multiple
VLANs
Hybrid port
When assigning an access or hybrid port to a VLAN, make sure the VLAN already exists.
2) In VLAN view
Follow these steps to assign one or multiple access ports to a VLAN in VLAN view:
To do...
Enter system view
Enter VLAN view
Use the command...
system-view
interface interface-type
interface-number
port link-type { access |
hybrid | trunk }
Use the command...
system-view
interface interface-type interface-number
port access vlan vlan-id
port trunk permit vlan { vlan-id-list | all }
port hybrid vlan vlan-id-list { tagged |
untagged }
Use the command...
system-view
vlan vlan-id
2-4
Remarks
—
—
Required
The link type of an Ethernet
port is access by default.
Remarks
—
—
Optional
By default, all
Ethernet ports
belong to VLAN
1.
Remarks
—
Required
If the specified VLAN does not
exist, this command creates the
VLAN first.