Info-Center Console Channel - 3Com 8807 Command Reference Manual

info-center console
channel
channel-name: Specifies the channel name with a character string not exceeding
30 characters, excluding digit, "-", "/" or "". .
Description
Use the info-center channel name command to rename a channel specified by
the channel-number as channel-name.
Use the undo info-center channel command to restore the channel name.
The system assigns a channel in each output direction by default. See the table
below.
Table 144 Numbers and names of the channels for log output
Output direction
Console
Monitor
Info-center loghost
Trap buffer
Logging buffer
snmp
Log file
Note that the channel name cannot be duplicated.
Example
# Rename the channel 0 as execconsole.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] info-center channel 0 name execconsole
Syntax
info-center console channel { channel-number | channel-name }
undo info-center console channel
View
System view
Parameter
channel-number: Channel number, ranging from 0 to 9, that is, system has ten
channels.
channel-name: Specifies the channel name. The name can be channel7,
channel8, channel9, console, logbuffer, loghost, monitor, snmpagent,
trapbuffer, logfile.
Description
Use the info-center console channel command to configure the channel
through which the log information is output to the console.
Information Center Configuration Commands
Channel number
0
1
2
3
4
5
6
1009
Default channel name
console
monitor
loghost
trapbuf
logbuf
snmpagent
Logfile