Basic System Configuration And Debugging - 3Com E4500-24 Cli Configuration Manual

2

Basic System Configuration and Debugging

When configuring basic system configuration and debugging, go to these sections for information you
are interested in:
Basic System Configuration
Displaying the System Status
Debugging the System
Basic System Configuration
Perform the following basic system configuration:
To do...
Set the current date
and time of the
system
Set the local time
zone
Set the name and
time range of the
summer time
Enter system view
from user view
Set the system
name of the switch
Return from current
view to lower level
view
Return from current
view to user view
Use the command...
clock datetime
HH:MM:SS
{ YYYY/MM/DD |
MM/DD/YYYY }
clock timezone
zone-name { add | minus }
HH:MM:SS
clock summer-time
zone_name { one-off |
repeating } start-time
start-date end-time
end-date offset-time
system-view
sysname sysname
quit
return
2-1
Remarks
Required
Execute this command in user view.
The default value is 23:55:00 04/01/2000 when
the system starts up.
Optional
Execute this command in user view.
By default, it is the UTC time zone.
Optional
Execute this command in user view.
When the system reaches the specified
start time, it automatically adds the
specified offset to the current time, so as to
toggle the system time to the summer time.
When the system reaches the specified end
time, it automatically subtracts the specified
offset from the current time, so as to toggle
the summer time to normal system time.
—
Optional
By default, the name is 3Com.
Optional
If the current view is user view, you will quit the
current user interface.
Optional
The composite key <Ctrl+Z> has the same
effect with the return command.