Display Startup - 3Com 5500-EI PWR Reference Manual

#
undo xrn-fabric authentication-mode
#GLBCFG. MUST NOT DELETE
#
interface NULL0
#
user-interface aux 0 7
user-interface vty 0 4
authentication-mode none
user privilege level 3
#
return
The configuration information output above in turn is the system configuration, logical interface
configuration, physical port configuration, and user interface configuration.

display startup

Syntax
display startup [ unit unit-id ]
View
Any view
Parameters
unit unit-id: Specifies the unit ID of a switch. With this keyword-argument combination specified, this
command can display the startup configuration file information of the specified unit.
Description
Use the display startup command to display the startup configuration of a switch.
Note that:
If the switch is not a unit of a fabric, this command displays the startup configuration file information
of the current switch no matter whether you have specified the unit-id argument or not.
If the switch is a unit of a fabric, without unit-id specified, this command displays the startup
configuration file information of all the units in the fabric; with unit-id specified, this command
displays the startup configuration file information of the specified unit.
Related commands: startup saved-configuration.
Examples
# Display the startup configuration file information of the current switch, which is not in any fabric.
<Sysname> display startup
UNIT1:
Current Startup saved-configuration file:
Next main startup saved-configuration file:
Next backup startup saved-configuration file:
Bootrom-access enable state:
flash:/config.cfg
flash:/config.cfg
flash:/backup.cfg
enabled
1-8