Dot1X Version-Check; Reset Dot1X Statistics - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – 802.1x

1.1.15 dot1x version-check

Syntax
dot1x version-check [ interface interface-list ]
undo dot1x version-check [ interface interface-list ]
View
System view, Ethernet port view
Parameter
interface-list: Ethernet port list. You can specify multiple Ethernet ports by providing this
argument in the form of interface-list = { interface-name [ to interface- name] & < 1-10 >.
The interface-name argument is the port index of an Ethernet port and can be specified
in this form: interface-name = { interface-type interface-num }, where interface-type
specifies the type of a port and interface-num identifies the port number. "&<1-10>"
means that up to 10 port indexes/port index lists can be provided.
Description
Use the dot1x version-check command to enable 802.1x client version checking for
specified Ethernet ports.
Use the undo dot1x version-check command to disable 802.1x client version
checking for specified Ethernet ports.
By default, 802.1x client version checking is disabled on all Ethernet ports.
In system view, execution of the dot1x version-check command enables the client
version checking function for specified ports if the interface-list argument is specified,
otherwise it enables the function globally. In Ethernet port view, only the current port
can have their client version checking function enabled by executing this command and
the interface-list argument is not needed.
Example
# Configure Ethernet 3/0/1 port to check the version of the 802.1x client upon receiving
authentication packets.
<3Com>system-view
System View: return to User View with Ctrl+Z.
[3Com] interface Ethernet 3/0/1
[3Com-Ethernet3/0/1] dot1x version-check

1.1.16 reset dot1x statistics

Syntax
reset dot1x statistics [ interface interface-list ]
Chapter 1 802.1x Configuration Commands
1-20