Canon imageRUNNER ADVANCE C5500 Series Service Manual page 670

43-0072 -
A. Operation / B. Cause /
C. Remedy
43-0073 -
A. Operation / B. Cause /
C. Remedy
43-0076 -
A. Operation / B. Cause /
C. Remedy
50-0015 -
A. Operation / B. Cause /
C. Remedy
61-0002 -
A. Operation / B. Cause /
C. Remedy
70-0086 -
A. Operation / B. Cause /
C. Remedy
83-1001 -
A. Operation / B. Cause /
C. Remedy
83-1002 -
A. Operation / B. Cause /
C. Remedy
Drum Unit (C) replacement completion alarm
The replacement of the Drum Unit was detected.
Drum Unit (Bk) replacement completion alarm
The replacement of the Drum Unit was detected.
Fixing Assembly replacement completion alarm
The counter of the Fixing Assembly was cleared.
Failure of the ADF Double Feed Sensor
Cause:
Failure of the Double Feed Sensor installed in the ADF
Detection condition/timing:
- When a paper feed error of the Double Feed Sensor was detected at power-on
- When an error of the output value of the Double Feed Sensor was detected during ADF job (While
an ADF job is being executed, it is handled as a jam once and retry is performed.)
Clearing condition:
- When communication and the sensor output value are normal at power-on
Movement/symptom: "Check area where multi. sheet feed was detected. (Call serv. rep.)" is
displayed in the status line. Although reading from the ADF is possible, double feed cannot be
detected when it occurs.
Measures:
Check for any foreign matter, clean paper lint, disconnect and then connect the connectors, replace
the Double Feed Detection PCB, replace the RCON/DF Driver PCB, replace the harnesses
Finisher Staple Free Stapling alarm: Fin-H1/Y1
Cause: The staple free staple unit is broken.
Operation : Operation stops as jam. After jam processing, the paper is delivered without stapling
until a job is finished.
Recovery method : Replace the Staple free staple unit. After performing the remedy work, go
through the following to clear the alarm: SORTER> FUNCTION> EMSG-CLR.
For R&D
Network linked service
Cause:
- Resource full error of network linked service
Detection condition/timing: -
Movement/symptom:
- Memory or disk space enough for executing conversion process using network linked service
cannot be allocated.
Measures: -
Network linked service
Cause:
- Parameter error of network linked service
Detection condition/timing: -
Movement/symptom:
- Printing cannot be performed because of specifying unsupported document data or making the
unsupported print settings during data conversion process using network linked service.
Measures:
- Check that the format of the document data is correct.
- Check that the print settings are correct.
656
7. Error/Jam/Alarm