Canon imageRUNNER ADVANCE C5500 Series Service Manual page 431

Create a test chart using a A4 or LTR size paper, by drawing a rectangle 10 mm smaller than the paper at four corners.
NOTE:
Write a character or a symbol to indicate the orientation of the printed image.
■ Eased Angle Guide (Opening Angle of 90 Degrees)
Change the opening angle of the ADF from 70 degrees to 90 degrees.
NOTE:
Some operation become easier by making the DADF opening angle wider.
1. Turn over the cover and remove the Angle Guide Plate.
• 4 Screws
CAUTION:
After adjustment, be sure to install the Angle Guide Plate.
■ Adjustment of the Tray Width
Execute either "AB configuration adjustment" or "Inch configuration adjustment" for this adjustment.
● AB Configuration Adjustment
1. Highlight the service mode item in the following service mode.
• FEEDER > FUNCTION > TRY-A4
2. Align the Slide Guide with "A4/A3".
3. Press the OK key and register the width of A4.
10 mm
10 mm
10 mm
Hinge Covers
x4
Hinge Open/Close
Guide Plate
417
10 mm
Hinge Open/Close
Guide Plate
5. Adjustment