Canon imageRUNNER ADVANCE C5500 Series Service Manual page 946

COPIER > OPTION > NETWORK
DNSTRANS 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
PROXYRES 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
WOLTRANS 1
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
802XTOUT 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Setting of DNS query priority protocol
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set priority of the protocol (IPv4/IPv6) for DNS query.
In the case of using both IPv6 and IPv4 while the DNS server supports IPv4, it takes time because
of timeout when executing DNS query with priority on IPv6. Giving priority on query by IPv4 can
shorten the time.
When it takes time to execute DNS query with priority on IPv6 because the DNS server supports
IPv4
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: IPv4, 1: IPv6
1
Setting of proxy response to Windows
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to provide proxy response or return the device status when an inquiry is received
via Windows while the device is in sleep mode.
When executing status response for query from Windows correctly
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: No proxy response, 1: Proxy response
1
ON/OFF sleep recover by packet reception
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to recover from deep sleep when receiving unicast packets to the machine
(excluding proxy response).
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
1 to 2
1: ON, 2: OFF
1
Set of IEEE802.1X authentication timeout
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set timeout value for IEEE802.1X authentication.
If the device executes 802.1X authentication, change the wait time for response from the
authentication server.
When response from the authentication server is slow/fast
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
10 to 120
sec
30
1
932
8. Service Mode