Canon imageRUNNER ADVANCE C5500 Series Service Manual page 631

747-8514-00
Detection Description
Remedy
747-8515-00
Detection Description
Remedy
747-8516-00
Detection Description
Remedy
747-8517-00
Detection Description
Remedy
747-8519-00
Detection Description
Remedy
Board error
There was unexpected interruption from ASIC.
[Related parts] R1.00
- Harness betweens the Reader Controller PCB (UN_BO1/J109) and the Riser PCB (J7)
- Bypass PCB (when non-Canon-made controller is installed)
- Open I/F PCB (when non-Canon-made controller is installed)
- Riser PCB
- Main Controller PCB
- HDD
[Remedy] Check/replace the related harness/cable, connector and parts.
Board error
There was unexpected interruption from ASIC.
[Related parts] R1.00
- Harness betweens the Reader Controller PCB (UN_BO1/J109) and the Riser PCB (J7)
- Bypass PCB (when non-Canon-made controller is installed)
- Open I/F PCB (when non-Canon-made controller is installed)
- Riser PCB
- Main Controller PCB
- HDD
[Remedy] Check/replace the related harness/cable, connector and parts.
Board error
There was unexpected interruption from ASIC.
[Related parts] R1.00
- Harness betweens the Reader Controller PCB (UN_BO1/J109) and the Riser PCB (J7)
- Bypass PCB (when non-Canon-made controller is installed)
- Open I/F PCB (when non-Canon-made controller is installed)
- Riser PCB
- Main Controller PCB
- HDD
[Remedy] Check/replace the related harness/cable, connector and parts.
Board error
There was unexpected interruption from ASIC.
[Related parts] R1.00
- Harness betweens the Reader Controller PCB (UN_BO1/J109) and the Riser PCB (J7)
- Bypass PCB (when non-Canon-made controller is installed)
- Open I/F PCB (when non-Canon-made controller is installed)
- Riser PCB
- Main Controller PCB
- HDD
[Remedy] Check/replace the related harness/cable, connector and parts.
Board error
There was unexpected interruption from ASIC.
[Related parts] R1.00
- Harness betweens the Reader Controller PCB (UN_BO1/J109) and the Riser PCB (J7)
- Bypass PCB (when non-Canon-made controller is installed)
- Open I/F PCB (when non-Canon-made controller is installed)
- Riser PCB
- Main Controller PCB
- HDD
[Remedy] Check/replace the related harness/cable, connector and parts.
617
7. Error/Jam/Alarm