Canon imageRUNNER ADVANCE C5500 Series Service Manual page 882

COPIER > FUNCTION > INSTALL
STIR-K 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Required Time
Related Service Mode
STIR-4 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Required Time
Related Service Mode
STRD-POS 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Required Time
Related Service Mode
CARD 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Stirring of Bk-color developer
To stir developer in the Bk-color Developing Unit.
- At installation of the machine
- When an image failure occurs
Select the item, and then press OK key.
During operation: ACTIVE, When operation finished normally: OK!
60 sec
COPIER> FUNCTION> INSTALL> STIR-Y/M/C/4
Stirring of all colors of developers
To stir developer in the Developing Units of 4 colors (Y/M/C/Bk).
- At installation of the machine
- When an image failure occurs
Select the item, and then press OK key.
During operation: ACTIVE, When operation finished normally: OK!
60 sec
COPIER> FUNCTION> INSTALL> STIR-Y/M/C/K
Auto adj frt side read pstn: DADF stream
To automatically adjust the Scanner Unit (for front side) position in feed direction when stream
reading original with DADF.
The adjustment result is reflected to COPIER> ADJUST> ADJ-XY> STRD-POS.
At DADF installation/uninstallation
1) Close the DADF.
2) Select the item, and then press OK key.
The operation automatically stops after the adjustment.
3) Write the value displayed by COPIER> ADJUST> ADJ-XY> STRD-POS in the service label.
Write the adjusted value in the service label.
At normal termination: OK, At abnormal termination: NG
10 sec
COPIER> ADJUST> ADJ-XY> STRD-POS
Card number setting
To set the card number to be used for Card Reader.
A series of numbers from the entered number to the number of cards specified by CARD-RNG
can be used.
- At installation of the Card Reader
- After replacement of the HDD
1) Enter the number, and then press OK key.
2) Turn OFF/ON the main power switch.
The card management information (department ID and password) is initialized.
1 to 2001
1
COPIER> OPTION> FNC-SW> CARD-RNG
868
8. Service Mode