Canon imageRUNNER ADVANCE C5500 Series Service Manual page 989

COPIER > OPTION > IMG-FIX
REC-LP 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
■ CUSTOM
COPIER > OPTION > CUSTOM
TEMP-TBL 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
SC-L-CNT 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
SCANTYPE 1
Set of fixing arch amount: recycled
To set the arch amount between secondary transfer and fixing when feeding recycled paper 1 to
3.
Usually, in case of recycled paper, fixing arch control is performed to make the arch small for paper
whose length (in feed direction) is 220.0 mm or less, whereas the control is performed to make
the arch large for paper whose length exceeds 220.0 mm.
Set 1 when an image failure (crepe marks) occurs. The arch becomes large when feeding recycled
paper regardless of paper length.
Set 0 when an image failure occurs on the trailing edge. The arch becomes small when feeding
recycled paper regardless of paper length.
When an image failure (crepe marks/image failure on the trailing edge) occurs with recycled paper
Enter the setting value, and then press OK key.
0 to 3
0: Small arch
1: Large arch
2: Small arch for paper whose length is 220.0 mm or less, large arch for paper whose length
exceeds 220.0 mm
3: Large arch for paper whose length is 220.0 mm or less, small arch for paper whose length
exceeds 220.0 mm
2
Set fixing control temp: plain paper 1
To set the offset of fixing control temperature for plain paper 1 (64 to 75 g/m2).
As the value is changed by 1, the temperature is changed by 5 deg C.
Increase the value when a fixing failure occurs, and decrease the value when fixing offset occurs.
When a fixing failure/fixing offset occurs on plain paper 1
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-2 to 2
-2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: +5 deg C, 2: +10 deg C
deg C
0
5
Set large paper jdgmt reference at scan
To set the judgment reference of the scan counter as to which to use B4 or LTR to determine large
size.
The threshold is determined by the combination with the setting of B4-L-CNT.
SC-L-CNT=0, B4-L-CNT=0: paper exceeding B4 is determined as large size, paper with B4 or
smaller is determined as small size.
SC-L-CNT=0, B4-L-CNT=1: paper with B4 or larger is determined as large size, paper smaller than
B4 is determined as small size.
As needed
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: B4 size, 1: LTR size
0
COPIER> OPTION> USER> B4-L-CNT
[Not used]
975
8. Service Mode