Canon imageRUNNER ADVANCE C5500 Series Service Manual page 996

COPIER > OPTION > USER
B4-L-CNT 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
MF-LG-ST 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Additional Functions
Mode
Supplement/Memo
CNT-DISP 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
COPY-JOB 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
OP-SZ-DT 2
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Count setting of B4 size
To set B4 count with software counter 1 to 8 as to whether B4 is counted as large size or small
size.
Selecting 1 counts B4 or larger size paper as large size while paper smaller than B4 size as small
size.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Small size, 1: Large size
0
COPIER> OPTION> CUSTOM> SC-L-CNT
Display/hide of long strip mode
To set whether to display or hide the [Long Original] button.
When 1 is set, [Long Original] button is displayed in Copy > Options screen and the long strip paper
becomes available.
Upon user's request (use of long strip original or long strip paper)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Hide, 1: Display
0
Copy> Options
Up to 630mm length paper is supported when DADF is used.
Display/hide of serial No.
To set whether to display or hide the serial No. on the Counter Check screen.
When setting to display/hide serial No. on the Counter Check screen.
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Display, 1: Hide
0
Setting of copy job reservation
To set to enable/disable copy job reservation when the Card Reader/Coin Manager is used.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Enabled, 1: Disabled
0
Orgnl size dtct ON/OFF at copyboard open
To set ON/OFF of original size detection while the Copyboard is opened.
When "0: OFF" is set, enter original size manually from the Control Panel.
When "1: ON" is set, original size is detected automatically.
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: OFF, 1: ON
0
982
8. Service Mode