Canon imageRUNNER ADVANCE C5500 Series Service Manual page 1053

COPIER > TEST > NET-CAP
PAYLOAD 2
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Additional Functions
Mode
FILE-CLR 2
Detail
Adj/Set/Operate Method
SIMPFILT 2
ENCDATA 2
CAPIF 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Set network packet capture data save
To set whether to discard payload when saving the captured packet data.
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Save captured packet data as is, 1: Discard payload and save the packet data
0
COPIER> TEST> NET-CAP
Store Network Packet Log
Deletion of network packet capture data
To delete the captured packet data.
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
For R&D
For R&D
Setting of network packet capture target
To set the network interface to capture the packet data.
Make this setting before starting network packet capture.
When changing the target of network packet capture
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
1 to 5
1: Local loopback, 2: Wired LAN, 3: Wireless LAN, 4: Not used, 5: Wi-Fi direct/Wireless Soft AP
mode
°
2
COPIER> TEST> NET-CAP
1039
8. Service Mode