Canon imageRUNNER ADVANCE C5500 Series Service Manual page 871

COPIER > ADJUST > FEED-ADJ
ADJ-C1RE 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
ADJ-C2RE 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
ADJ-C3RE 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Write start pstn in horz scan: Cst1,2nd
To adjust the image write start position on the second side in the horizontal scanning direction
when feeding paper from the Cassette 1.
As the value is changed by 1, the left margin is changed by 0.1 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
When replacing the DC Controller PCB/clearing RAM data, enter the value of service label.
When replacing the DC Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-55 to 55
mm
0
0.1
Write start pstn in horz scan: Cst2,2nd
To adjust the image write start position on the second side in the horizontal scanning direction
when feeding paper from the Cassette 2.
As the value is changed by 1, the left margin is changed by 0.1 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
When replacing the DC Controller PCB/clearing RAM data, enter the value of service label.
When replacing the DC Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-55 to 55
mm
0
0.1
Write start pstn in horz scan: Cst3,2nd
To adjust the image write start position on the second side in the horizontal scanning direction
when feeding paper from the Cassette 3.
As the value is changed by 1, the left margin is changed by 0.1 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
When replacing the DC Controller PCB/clearing RAM data, enter the value of service label.
When replacing the DC Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-55 to 55
mm
0
0.1
857
8. Service Mode