Canon imageRUNNER ADVANCE C5500 Series Service Manual page 953

COPIER > OPTION > NETWORK
LINKWAKE 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
WIFIRFCH 2
Amount of Change per
Unit
BLEPOWER 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
■ ENV-SET
COPIER > OPTION > ENV-SET
ENVP-INT 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Amount of Change per
Unit
DRY-CISU 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Set of deep sleep recovery at link-up
To set whether to recover from deep sleep when link-up (disconnection and then connection of
LAN cable) is detected.
Set 0 if the closest hub or switch chatters at link-up. It can prevent recovery from deep sleep
triggered by chattering.
When the machine recovers from deep sleep due to chattering of the closest hub or switch
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Not recovered, 1: Recovered
1
For R&D
1
Set of Bluetooth radio field strength
To set the radio field strength for transmission over BLE (Bluetooth Low Energy).
As the value is changed by 1, the radio field strength is changed by 1 dBm.
When radio field strength of BLE is not appropriate
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
Do not change the setting in Singapore. It is prohibited by law.
-10 to -1 (-10 to -1 dBm)
-5
Temp&hmdy/Fix Film temp log get cycle
To set the cycle to obtain log of the temperature and humidity inside the machine and the surface
temperature of the Fixing Film.
As the value is incremented by 1, the cycle is increased by 1 minute.
Collected log can be displayed in COPIER> DISPLAY> ENVRNT.
At problem analysis
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 480
min
60
COPIER> DISPLAY> ENVRNT
1
ON/OFF of condensation prevention mode
To set ON/OFF of condensation prevention mode.
Set 1 when an image failure or E225 occurs due to condensation in the Scanner Unit. From the
next startup, the Scanner Unit (for front side) stops the fan for 15 sec and the Scanner Unit (for
back side) lights LED for 30 sec.
When droplets appear on the Scanner Unit due to condensation and image failure or E225 occurs
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: OFF (Normal mode), 1: ON (Condensation prevention mode)
0
939
8. Service Mode