Canon imageRUNNER ADVANCE C5500 Series Service Manual page 545

516-0001-02
Detection Description
Remedy
516-0002-02
Detection Description
Remedy
530-8001-02
Detection Description
Remedy
Paddle Motor error (Finisher-H1)
- The Paper Fold HP Sensor was not turned OFF although 3 seconds had passed after the Paddle
Motor operation started.
- The last paper fold operation is not finished when driving the Paddle Motor.
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Paper Fold HP Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Paddle Motor
- Paper Fold HP Sensor (PS8)
- Paddle Motor (M10)
- Finisher Controller PCB (PCB1)
[Remedy] Check/replace the corresponding harnesses/cables or connectors or the parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
Paddle Motor error (Finisher-H1)
- The Paper Fold HP Sensor was not turned ON although 3 seconds had passed after the Paddle
Motor operation started.
- The last paper fold operation is not finished when driving the Paddle Motor.
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Paper Fold HP Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Paddle Motor
- Paper Fold HP Sensor (PS8)
- Paddle Motor (M10)
- Finisher Controller PCB (PCB1)
[Remedy] Check/replace the corresponding harnesses/cables or connectors or the parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
a. Rear Alignment Motor error (Finisher-H1) b. Error in the Front Alignment Motor (Finisher-
Y1)
a. The Rear Alignment Plate HP Sensor was not turned OFF although 1 second had passed after
the Rear Alignment Motor operation started.
b. The front alignment plate does not come off the Front Alignment HP Sensor when the Front
Alignment Motor has been driven for 1 second.
a. INNER FIN-H1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Rear Alignment Plate HP
Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Rear Alignment Motor
- Rear Alignment Plate HP Sensor (PS5)
- Rear Alignment Motor (M4)
- Finisher Controller PCB (PCB1)
b.STAPLE FIN-Y1/BOOKLET FIN-Y1
[Related parts]
- Harnesses from the Front Alignment HP Sensor (PS115) to the Finisher Controller PCB
- Harnesses from the Front Alignment Motor (M107) to the Finisher Controller PCB
- Front Alignment HP Sensor (PS115)
- Front Alignment Motor (M107)
- Finisher Controller PCB (PCB101)
[Points to note at work] When the Swing Guide Safety Switch (SW102) turns on at the detection
timing of this error, this error code may be displayed. Accordingly, perform the following work before
checking the related parts.
1. Check whether there is not the mulfunction in the swing guide unit.
2. Check whether there is not the mulfunction in the Swing Guide Safety Switch (SW102).
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
531
7. Error/Jam/Alarm