Canon imageRUNNER ADVANCE C5500 Series Service Manual page 1036

COPIER > OPTION > LCNS-TR
ST-PSPCU 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
TR-PSPCU 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
ST-LXUFR 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
TR-LXUFR 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
ST-HDCR2 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Install state dspl of PS/PCL/UFR II func
To display installation state of PS/PCL/UFR II function when disabling and then transferring the
license.
When checking whether PS/PCL/UFR II function is installed
1) Select ST-PSPCU.
2) Enter 0, and then press OK key.
When installation has been completed, the transfer license key is displayed under TR-PSPCU.
When operation finished normally: OK!
According to the setting at shipment
Trns lcns key dspl of PS/PCL/UFR II func
To display transfer license key to use PS/PCL/UFR II function when disabling and then transferring
the license.
- When replacing HDD
- When replacing the device
1) Select ST-PSPCU.
2) Enter 0, and then press OK key.
The transfer license key is displayed under TR-PSPCU.
24 digits
Install state display of UFR II function
To display installation state of UFR II function when disabling and then transferring the license.
When checking whether UFR II function is installed
1) Select ST-LXUFR.
2) Enter 0, and then press OK key.
When installation has been completed, the transfer license key is displayed under TR-LXUFR.
When operation finished normally: OK!
According to the setting at shipment
Trns license key dspl of UFR II function
To display transfer license key to use UFR II function when disabling and then transferring the
license.
- When replacing HDD
- When replacing the device
1) Select ST-LXUFR.
2) Enter 0, and then press OK key.
The transfer license key is displayed under TR-LXUFR.
24 digits
Install state dspl:HDD Init All Data/Set
To display installation state of HDD Initialize All Data/Settings when disabling and then transferring
the license.
When checking whether HDD Initialize All Data/Settings is installed
1) Select ST-HDCR2.
2) Enter 0, and then press OK key.
When installation has been completed, the transfer license key is displayed under TR-HDCR2.
When operation finished normally: OK!
0
1022
8. Service Mode