CAUTION:
• After installing the Primary Transfer Roller (C, M, Y), turn the ITB Sub Pressure Release Lever [1] to check that the
Primary Transfer Roller (C, M, Y) moves up and down.
• After performing the check, lower the Primary Transfer Roller (C, M, Y).
CAUTION:
Actions after
Replacement:"Adjustment Procedure" on page 433
Removing the Secondary Transfer Inner Roller
■ Preparation
1. Removing the ITB
Unit"Removing the ITB Unit" on page 283
2. Removing the ITB Cleaning
3. Removing the
ITB"Removing the ITB" on page 295
■ Procedure
CAUTION:
Do not touch the surface of the Drive Roller [1], Secondary Transfer Inner Roller [2] and Primary Transfer Roller [3];
otherwise, it can cause an image failure.
1. Pull out the pin [1] and straighten the Secondary Transfer Inner Roller Unit [2].
(C)
(M)
Unit"Removing the ITB Cleaning Unit" on page 290
[1]
(Y)
[1]
[2]
[3]
307
4. Disassembly/Assembly