Canon imageRUNNER ADVANCE C5500 Series Service Manual page 847

COPIER > ADJUST > COLOR
PL-OFS-M 2
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Additional Functions
Mode
Supplement/Memo
PL-OFS-C 2
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Additional Functions
Mode
Supplement/Memo
Adj M-clr low dens area clr balance: PDL
To adjust the color balance of the low density area of M-color at PDL print.
As the value is larger, the image gets darker.
In case of data generated by the printer driver and stored in Mail Box, a value obtained by adding
the value adjusted in [Fine Adjust Density] in [Access Stored Files] to the setting value of this item
is applied as the actual density value.
e.g.: When the value of this item is "-4" and the value of [Fine Adjust Density] is "5", the density
value is "1".
Note that the density value must be within the rage from -8 to 8.
e.g.: When the value of this item is "7" and the value of [Fine Adjust Density] is "5", the density
value is "8".
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-8 to 8
0
Copy> Options> Color Balance> Fine Adjust Density
Access Stored Files> Mail Box> Print> Change Print Settings> Options> Color Balance> Fine
Adjust Density
Adjustment/Maintenance> Adjust Image Quality> Color Balance> Non-Coated> Fine Adjust
Density
Adjustment/Maintenance> Adjust Image Quality> Color Balance> Coated> Fine Adjust Density
In [Fine Adjust Density] in [Adjustment/Maintenance], the same value is set as the density for copy
operation and file storage.
In [Fine Adjust Density] under [Copy] and [Access Stored Files] in the main menu, the density value
can be set individually. Although the setting value of this item is just one value, the density may
differ for copy operation and file storage.
Adj C-clr low dens area clr balance: PDL
To adjust the color balance of the low density area of C-color at PDL print.
As the value is larger, the image gets darker.
In case of data generated by the printer driver and stored in Mail Box, a value obtained by adding
the value adjusted in [Fine Adjust Density] in [Access Stored Files] to the setting value of this item
is applied as the actual density value.
e.g.: When the value of this item is "-4" and the value of [Fine Adjust Density] is "5", the density
value is "1".
Note that the density value must be within the rage from -8 to 8.
e.g.: When the value of this item is "7" and the value of [Fine Adjust Density] is "5", the density
value is "8".
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-8 to 8
0
Copy> Options> Color Balance> Fine Adjust Density
Access Stored Files> Mail Box> Print> Change Print Settings> Options> Color Balance> Fine
Adjust Density
Adjustment/Maintenance> Adjust Image Quality> Color Balance> Non-Coated> Fine Adjust
Density
Adjustment/Maintenance> Adjust Image Quality> Color Balance> Coated> Fine Adjust Density
In [Fine Adjust Density] in [Adjustment/Maintenance], the same value is set as the density for copy
operation and file storage.
In [Fine Adjust Density] under [Copy] and [Access Stored Files] in the main menu, the density value
can be set individually. Although the setting value of this item is just one value, the density may
differ for copy operation and file storage.
833
8. Service Mode