5. Remove the Pressure Roller [1] and the 2 Pressure Roller Bearings [2] from the Pressure Roller Unit.
• 2 Bearing Holders [3]
CAUTION:
Actions at Replacement
In order to prevent abnormal noise, be sure to apply a small amount (20 mg on each side) of grease to the bearing fitting
part of the Fixing Pressure Roller Shaft shown in the figure below when replacing the Fixing Pressure Roller Unit. (Just
apply a thin layer in the circumferential direction.)
Grease that can be used: CK-8102 (HP300), QY-0035 (HP300), and FY9-6036 (SE1107)
Grease : 20 mg
• Never apply grease to the surface of the Fixing Pressure Roller.
• Do not use grease other than those above.
• This unit is dedicated to iR-ADV C5500 series.
This cannot be used for iR-ADV C5200/C5000 series.
Removing the 27T Gear
■ Preparation
1. Open the Right Lower Cover and the Right Upper Cover.
2. Removing the Fixing
[2]
[3]
Unit"Removing the Fixing Unit" on page 360
[2]
[1]
Grease : 20 mg
within 5.0 mm
370
4. Disassembly/Assembly
[3]