Canon imageRUNNER ADVANCE C5500 Series Service Manual page 915

COPIER > OPTION > FNC-SW
ORG-LTRR 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
ORG-LDR 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
ORG-B5 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
INTROT-1 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Amount of Change per
Unit
Special paper size set in DADF mode:LTRR
To set the size of special paper (LTR-R configuration) that cannot be recognized in DADF stream
reading mode.
- Upon user's request
- When picking up special paper size original from DADF
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 5
0: LTR-R, 1: G-LTR-R, 2: A-LTR-R, 3: EXECUTIVE-R, 4: OFICIO-R, 5: Ecuador OFICIO-R
0
Special paper size set in DADF mode: LDR
To set the size of special paper (LDR configuration) that cannot be recognized in DADF stream
reading mode.
- Upon user's request
- When picking up special paper size original from DADF
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: LEDGER-R, 1: Argentine LETTER
0
Special paper size set in DADF mode: B5
To set the size of special paper (B5) that cannot be recognized in DADF stream reading mode.
- Upon user's request
- When picking up special paper size original from DADF
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: B5, 1: Korean government office paper
0
Set ppr interval auto adj exe interval
To set the number of sheets as the intervals to execute automatic adjustments (discharge current
control and primary transfer ATVC control) at paper interval.
When the number of sheets reaches the specified value, the adjustments are executed at next
paper interval. After starting a job, however, the adjustments are not executed until the number of
sheets reaches the value set in INTPPR-2.
As the value is increased, frequency of the automatic adjustments becomes low so productivity is
increased.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
If the value is too large, image failure may occur.
50 to 1000
sheet
250
COPIER> OPTION> IMG-DEV> INTPPR-2
1
901
8. Service Mode