027-0200-05
Detection Description
Remedy
027-0300-05
Detection Description
Remedy
027-0400-05
Detection Description
Remedy
Error in supply with M Developing Assembly
The Toner Supply Screw Rotation Sensor detected rotation error within the specified period of
time.
[Related parts] R1.01
- Harness between the Feed/Drum Driver PCB (UN2/J225) and the Developing Motor (M) (M6/
J6013)
- Harness between the Feed/Drum Driver PCB (UN2/J212) and the Toner Sensor Relay PCB (M)
(UN40/J1410)
- Developing Motor (M) (M6)
- Developing Assembly (M)
- Main Drive Assembly
- Set-on Hopper Assembly
- Feed/Drum Driver PCB (UN2)
[Remedy] Perform the following in the order while checking whether the error is cleared.
1. Check that the Developing Coupling of the Developing Assembly is not damaged.
2. Check that the Developing Coupling of the Main Drive Assembly is not damaged.
3. Check/replace the related harness/cable, connector and parts.
Error in supply with C Developing Assembly
The Toner Supply Screw Rotation Sensor detected rotation error within the specified period of
time.
[Related parts] R1.01
- Harness between the Feed/Drum Driver PCB (UN2/J225) and the Developing Motor (C) (M7/
J6012)
- Harness between the Feed/Drum Driver PCB (UN2/J212) and the Toner Sensor Relay PCB (C)
(UN41/J1420)
- Developing Motor (C) (M7)
- Developing Assembly (C)
- Main Drive Assembly
- Set-on Hopper Assembly
- Feed/Drum Driver PCB (UN2)
[Remedy] Perform the following in the order while checking whether the error is cleared.
1. Check that the Developing Coupling of the Developing Assembly is not damaged.
2. Check that the Developing Coupling of the Main Drive Assembly is not damaged.
3. Check/replace the related harness/cable, connector and parts.
Error in supply with K Developing Assembly
The Toner Supply Screw Rotation Sensor detected rotation error within the specified period of
time.
[Related parts] R1.01
- Harness between the Feed/Drum Driver PCB (UN2/J225) and the Developing Motor (Bk) (M8/
J6011)
- Harness between the Feed/Drum Driver PCB (UN2/J212) and the Toner Sensor Relay PCB (Bk)
(UN42/J1430)
- Developing Motor (Bk) (M8)
- Developing Assembly (Bk)
- Main Drive Assembly
- Set-on Hopper Assembly
- Feed/Drum Driver PCB (UN2)
[Remedy] Perform the following in the order while checking whether the error is cleared.
1. Check that the Developing Coupling of the Developing Assembly is not damaged.
2. Check that the Developing Coupling of the Main Drive Assembly is not damaged.
3. Check/replace the related harness/cable, connector and parts.
507
7. Error/Jam/Alarm